Shaker Table Part 2

Wow! It has been a LONG time since my last update. I guess Christmas and New Years got in the way there somewhere. I hope everyone had a good Christmas and New Year break as I did.

Ok, so back to this table. Last time I left off I had milled the four leg blanks to size and was getting ready to mill the leg rails. Once I milled up the leg rails, I needed to lay out for the mortise and tenon joins. I probably do things a little different, but thats just the way I am; I cut my mortises before I do my tenons. I guess the reason I do it this way is because I have a mortising machine and the chisels are a defined dimension and I can cut the tenons to match this. Also, because the side and back rails are 5" wide, I will be using a haunched tenon in order to add strength to the joint. If I used just one big mortise and tenon, the legs would be very weak because of all the material that would be removed. So, after I laid out how I wanted the mortises to be, I drilled them out with the mortiser and cut the tenons to match.

From Shaker Table

After that, I was able to do a dry fit on the table.

From Shaker Table

If you notice, I have not cut the tapers on the legs yet; this is done after the mortises are cut so the legs are always flat will doing the mortises. It also serves as a bit of a reference when you do go to cut the tapers because you know to always taper the mortised side. Here, the legs were tapered on the bandsaw and cleaned up with hand planes.

From Shaker Table

Now the table frame is ready to be glued up. While that is being done, I can get the drawer runners cut and glued in; nothing special about these, just some pieces that will be glued to the sides and allow the drawer to set on and provide support from the bottom.

Next, its time to turn my attention to the drawer itself, but that is for later.

Be Safe!